- A Phillips head screwdriver
- A flat head screwdriver
- A Torx T20 screwdriver
- A radio removal tool (optional)
Instructions:
1. Turn off the car and disconnect the battery. This will prevent any electrical damage while you are working.
2. Locate the two screws that hold the center console in place. They are located at the bottom of the console, near the ashtray.
3. Remove the two screws and then gently pry the center console out of place. Be careful not to damage the trim.
4. Locate the four screws that hold the radio in place. They are located on the side of the radio, two on each side.
5. Remove the four screws and then gently pull the radio out of the dash. Be careful not to damage the wiring.
6. Disconnect the wiring harness and the antenna from the radio.
7. Install the new radio in the reverse order of removal.
Here are some additional tips:
- If you are having trouble removing the center console, you can use a flat head screwdriver to pry it out of place.
- If you are having trouble removing the radio, you can use a radio removal tool to help you.
- Be careful not to damage the wiring when you are disconnecting it.