Replacing Headlight Lens on 1988 Saab 900: DIY Procedure
Tools Needed
- 10 mm socket/wrench
- Phillips screwdriver
- Flathead screwdriver (for clips)
- New headlight lens/assembly
- Gloves, clean rag
Procedure
- Prepare: Park on level ground, engine off/cool, hood open.
- Locate assembly: Front corners, beside grille.
- Remove mounting bolts: Four 10 mm bolts (two top, two bottom/side). Some models have plastic covers over top bolts.
- Disconnect wiring: Press release tab on connector at rear of assembly; pull straight out.
- Remove assembly: Pull forward gently. Guide wiring through opening.
- Replace lens: If replacing lens only (not full assembly), this requires separating lens from housing—often heat/sealant work. Replacing the full assembly is recommended for DIYers.
- Install new assembly: Reverse removal. Seat connector firmly until click.
- Torque bolts: Snug + 1/4 turn (don't over-tighten plastic mounts).
- Test: Verify high/low beams, turn signals, parking lights.
- Align: Check beam pattern on wall; adjust via alignment screws if needed.
Tips
- Work on one side at a time for reference.
- Don't touch halogen bulb glass with bare hands—oil causes hot spots/failure.
- If lens is cracked but housing intact, temporary repair with clear epoxy/tape possible until replacement.
- Euro/US spec lights differ—verify correct part number.
Safety: Proper headlight aim is critical. If unsure, have a shop align after installation.