DIY Guide: Replacing a Side Window in a 1992 Plymouth Sundance
Replacing a side window regulator in a 1992 Plymouth Sundance is a manageable weekend project if you have basic tools and patience. This step-by-step guide walks you through the process.
Tools You'll Need
- Screwdriver set (Phillips and flathead)
- Socket wrench set (typically 10mm bolts)
- Trim removal tool or flathead screwdriver (for prying)
- Replacement window regulator
- Gloves and safety glasses
Step-by-Step Instructions
- Remove the Door Panel: Locate and unscrew the four corner screws securing the panel. Gently pry the panel away from the door frame, disconnecting any electrical connectors for power windows or locks. Set the panel aside safely.
- Remove the Foam Lining: Peel back the protective foam or plastic moisture barrier. This lining protects the glass and mechanism; try to keep it intact for reinstallation.
- Locate the Window Regulator: Behind the foam, you'll see the metal frame of the regulator assembly attached to the door structure.
- Remove Regulator Bolts: Using your socket wrench, remove the bolts securing the regulator to the door frame (usually four). Support the regulator as you remove the last bolt so it doesn't fall.
- Pry Regulator from Door Frame: Carefully maneuver the old regulator out through the access holes in the door frame. Avoid bending the frame or damaging the door's interior structure.
- Position the New Window in Track: Before installing the new regulator, ensure the window glass is correctly seated in its track. This may require manually guiding the glass.
- Install New Regulator: Insert the new regulator, align the bolt holes, and replace the bolts. Tighten securely but avoid over-torquing.
- Replace Foam Lining: Reposition the moisture barrier, ensuring it seals properly to prevent water leaks and wind noise.
- Reattach Door Panel: Align the panel's clips and screw holes. Reconnect electrical connectors. Insert and tighten the four corner screws. Test the window operation before fully cleaning up.
Tips for Success
- Take photos during disassembly to remember connector routing and clip locations.
- Work on a warm day or in a heated garage; cold plastic clips become brittle and snap easily.
- If the window glass itself is being replaced, handle with extreme care and use suction cups.