Tools Required
- A #2 Phillips head screwdriver
- A plastic pry tool or butter knife
- Radio removal keys (or you can use two bent coat hangers)
1. Turn Off Power: Ensure that the car's engine is turned off and the ignition key is removed. Disconnect the battery's negative terminal as an extra safety precaution.
2. Locate Radio Bezel: The radio on the Saab 9-3 2003 is typically within the center console. Look for the panel surrounding the radio (the radio bezel).
3. Pry Open Radio Bezel: Insert the plastic pry tool into the gaps between the radio bezel and the dashboard. Gently pry the bezel away from the dashboard, working your way around the edges until the entire bezel comes off.
4. Disconnect Radio Harness: Once the radio bezel is removed, you'll see the radio unit inside. Locate the wiring harness connected to the back of the radio. Pinch the release tabs on the connectors and carefully disconnect them.
5. Remove Radio Bolts: There are two bolts, usually located on either side of the radio unit. Use the Phillips head screwdriver to loosen and remove these bolts. Then, gently pull the radio unit out from the dashboard while supporting its weight.
6. Remove Radio Keys or Coat Hangers: If your car has radio keys, insert them into the slots on either side of the unit and turn them counterclockwise to unlock the radio. If you don't have the radio keys, you can use two bent coat hangers instead. Insert the coat hangers into the slots and turn them counterclockwise.
7. Pull Out the Radio: Once the radio is unlocked, you can pull it out completely from the dashboard. Be careful not to drop it.
Note: The steps outlined here are general guidelines, and the specific details and locations may vary depending on the exact model of your Saab 9-3 2003. If you encounter any difficulties, it's always a good idea to refer to the owner's manual or consult a professional.