Coaxial Cable from Aerial to TV: A Complete Installation Guide
A direct coaxial connection from a rooftop aerial to a television provides free-to-air broadcast reception. Here is the complete procedure.
Materials Needed
- RG-6 coaxial cable (sufficient length + 10% slack)
- Two F-type compression connectors (pre-installed or crimp-on)
- Compression tool (if crimping yourself)
- Cable clips/staples for routing
Step 1: Measure and Prepare Cable
Run cable from aerial downlead to TV location. Avoid sharp bends (minimum radius: 3 inches), power lines, and tight staples. Leave service loops at both ends.
Step 2: Connect to Aerial
- Locate aerial's F-type output jack (labeled "RF OUT" or "TV OUT").
- Screw connector on clockwise until finger-tight, then ¼ turn with wrench.
- Weatherproof outdoor connection with self-amalgamating tape.
Step 3: Connect to Television
- Find TV's "ANT IN," "RF IN," or "CABLE/ANTENNA" jack.
- Attach cable connector using same method.
Step 4: Channel Scan
- TV Menu → Settings → Channels → Auto Scan / Channel Search.
- Select "Air" or "Antenna" (not "Cable").
- Wait for completion (2–5 minutes).
Step 5: Troubleshooting
- No channels: Check connections, re-scan, verify aerial orientation.
- Pixelation: Signal too weak—consider masthead amplifier.
- Missing specific channels: Re-scan after weather changes; some multiplexes are directional.
Quality Notes
Use RG-6 (not RG-59), compression connectors (not twist-on), and keep cable runs under 100 feet for best results. Splitters degrade signal—avoid unless feeding multiple TVs.