Using your screwdrivers, carefully unscrew the screws holding the camera frame together and remove the main body of the camera. Place the screws in one of your cups or jars and use paper to note they are the body screws so you can reassemble the camera afterward. Clean the body of any excess dirt or dust and set aside.
Open the lens housing using your smaller set of jewelers screwdrivers. The lens elements are very delicate, so be as gentle as possible. Again, put all of these screws in a separate, labeled container
Remove batteries from the battery compartment. Unscrew any remaining screws or bolts that are holding the battery compartment to the body of the camera. Follow the wires from the battery compartment to the camera motor and remove them by unscrewing their connections.
Disassemble the film transport mechanism. This is a series of gears and bearings connected to the motor and usually located behind the lens. Using your jewelers screwdrivers, remove the gears one by one, placing them into another separate and labeled container.
To remove the motor, find it in the handle or base of the camera and remove it using the appropriate-sized screwdriver. Locate any additional wires running from the motor and disconnect them before removing the motor.