DIY Yu-Gi-Oh Card Holder from Plywood
Materials
- 1/8" plywood (two 12"×18" pieces)
- 1/4" plywood (two 5"×12", two 5"×18")
- 110-lb cardstock
- Clear contact paper
- Scissors, craft knife, cutting mat, ruler, pencil, glue
Instructions
- Cut 1/8" plywood into two 12"×18" panels (front/back).
- Cut 1/4" plywood: two 5"×12" (center dividers), two 5"×18" (side dividers).
- Glue 5"×12" pieces to center of front panel, 3" from bottom.
- Glue 5"×18" pieces to sides of front panel, 1" from edges.
- Glue back panel to rear.
- Cover entire holder with contact paper.
- Cut cardstock into 3.5"×2.5" cards (standard size).
- Insert cardstock into each pocket.
Result: A sturdy, custom card holder with multiple pockets.