Connecting a Sound Lab G742 Mixer to 200W Passive Speakers: Cables and Setup
Cables & Setup for Sound Lab G742 + Passive Speakers
Clarification: The G742 is a powered mixer (built-in amp). Your speakers must be passive (unpowered). If speakers are active (powered), connect mixer's line outputs to speaker inputs.
For Passive Speakers (Standard)
- 2× SpeakON cables (NL2 or NL4) — Mixer amp outputs → Speaker inputs
- Length: Match your stage layout (10–50 ft typical)
For Signal Sources → Mixer
- XLR cables — Mics, DI boxes
- 1/4" TRS/TS cables — Instruments, line sources
- RCA cables — Playback devices
Connection Steps
- Power OFF everything
- Connect mixer amp outputs (SpeakON) → speaker inputs
- Connect sources → mixer inputs
- Set mixer gains low, master fader down
- Power ON: Sources → Mixer → (wait) → Speakers (if active)
- Slowly raise levels, check for feedback
- EQ: High-pass speakers (~80Hz), adjust to room
Optimization
- Speaker placement: ear level, angled inward, spaced wide
- Subwoofer: crossover ~100Hz if used
- Gain staging: maximize S/N ratio, avoid clipping