How to Wire a Mono Block Amplifier (Subwoofer Amp)
You need: Amp, 4-ga power/ground wire, RCA cables, speaker wire (12-16 ga), fuse holder (within 18" of battery), ring terminals, distro block (if multiple amps).
- Power: Run fused 4-ga from battery (+) to amp BAT+. Fuse at battery.
- Ground: 4-ga to clean chassis metal (scrape paint, star washer, bolt). Short as possible.
- Remote turn-on: 18-ga from head unit remote lead (blue/white) to amp REM.
- Signal: RCA from head unit SUB OUT / REAR to amp INPUT. Use quality shielded cable.
- Speaker: Amp (+) → Sub (+); Amp (−) → Sub (−). Match impedance (usually 2 Ω or 4 Ω).
- Set gain: Start low. Play 0 dB test tone (50 Hz). Raise gain until distortion, then back off 1/8 turn.
- Crossover: LPF ~80 Hz, 24 dB/oct. Subsonic filter ~30 Hz (if ported box).
Safety: Disconnect battery negative first. Never bridge a mono amp — it's already bridged internally.