Degaussing Reel-to-Reel Heads: Safe Demagnetizer Procedure for Audio Quality
Demagnetizing (degaussing) the heads removes residual magnetism that degrades high‑frequency response and adds noise. Follow this safe procedure:
- Power down & unplug the recorder. Remove any tape.
- Open the head cover to expose the erase, record, and playback heads.
- Position the demagnetizer: Hold its flat tip ~3 mm (⅛") from the head face, parallel to the gap.
- Activate & sweep: Turn on the demagnetizer. Slowly move it across the head gap (left‑right, top‑bottom) for 10‑15 seconds. Do not touch the head.
- Retract & power off: Pull the demagnetizer at least 2 feet away before turning it off. Switching it off near the head re‑magnetizes it.
- Repeat for each head (erase, record, playback).
- Close cover, plug in, and run a test recording.
Frequency: Every 50‑100 hours of use, or when high‑end clarity drops. Use only a demagnetizer designed for audio heads (AC, not permanent magnet).