Arts >> Music >> Recording Music

How to Install an Amplifier with a Factory Car Radio: Step-by-Step Guide

Step-by-Step: Adding an Amp to a Stock Head Unit

  1. Disconnect the negative battery terminal. Safety first.
  2. Run power wire from battery + to amp location (use fuse holder within 18" of battery).
  3. Ground the amp to clean, bare metal chassis point (short, thick wire).
  4. Connect RCA cables from head unit's preamp outputs (if available) OR use a line output converter (LOC) tapped into speaker wires.
  5. Run speaker wire from amp to speakers/subwoofer.
  6. Connect remote turn-on wire (blue/white) from head unit or LOC to amp.
  7. Reconnect battery.
  8. Set gains properly using a test tone or by ear—start low, raise until clean, then back off slightly.
  9. Enjoy!

Key tip: If your factory radio lacks RCA outs, a quality LOC (e.g., AudioControl LC2i, PAC SNI-35) is essential for clean signal.

Recording Music

Related Categories