Arts >> Music >> Recording Music

Installing the Image Audio Concepts IA-9901 Car Amplifier: 12-Step Guide

Installation steps for the IA-9901 car audio amplifier:

  1. Disconnect the vehicle battery (negative terminal first).
  2. Choose a mount location: Cool, dry, ventilated; away from engine/exhaust heat.
  3. Mount the amp: Use supplied screws; secure to chassis.
  4. Run power wire: 4- or 8-gauge from battery + to amp +; fuse within 18" of battery.
  5. Ground wire: Same gauge to clean, bare chassis metal near amp.
  6. Speaker wires: From amp outputs to speakers; proper polarity.
  7. RCA cables: From head unit pre-outs to amp inputs; route away from power wires.
  8. Remote turn-on: Thin wire from head unit remote/antenna lead to amp REM terminal.
  9. Set gains low: Turn head unit volume down; amp gain minimum.
  10. Reconnect battery. Power on; slowly raise gain until clean, loud output.
  11. Tune: Adjust crossover, bass boost, EQ to taste.
  12. Test: Listen for distortion; re-check connections if needed.

Follow the manual for model-specific details. Professional installation recommended if unsure.

Recording Music

Related Categories