Arts >> Music >> Musical Instruments

Removing Rear Brake Drum from Axle Flange: 1994 Plymouth Sundance — Step-by-Step Guide

Safety First: Secure vehicle on jack stands, chock front wheels, wear eye protection.

  1. Remove Wheel: Loosen lug nuts (before lifting), raise rear, remove lug nuts and wheel.
  2. Remove Drum Retaining Screws: Locate 1–2 small screws on drum face (threaded into hub). Remove with Phillips/flathead. If seized, use impact driver or drill out carefully.
  3. Release Parking Brake: Ensure parking brake is fully OFF. If cable is tight, adjust slack at equalizer.
  4. Pull Drum Off: Grasp drum edges and pull straight off. If stuck:
    • Tap drum face (not cooling fins) with rubber mallet/hammer (use wood block) to break rust bond.
    • Rotate drum while pulling.
    • If shoes bind drum: Insert screwdriver through backing plate access hole; turn star-wheel adjuster to retract shoes.
  5. Inspect Components: Check drum for scoring, heat cracks, out-of-round. Inspect shoes for wear (>1/16" lining), wheel cylinder leaks, hardware fatigue.
  6. Reassemble in Reverse: Clean mating surfaces. Adjust shoes to slight drag. Reinstall retaining screws, wheel, lug nuts (torque to spec). Pump brake pedal before driving.

Note: If drum is severely seized, a drum puller tool may be needed. Never use excessive heat near wheel bearings/seals.

Musical Instruments

Related Categories