Installing a New Horn on a 1990 Jeep Cherokee: Step-by-Step Guide
Replacing the horn on a 1990 Cherokee is a straightforward Saturday morning job. Here's the complete process:
Tools & Parts
- New horn (universal or OEM replacement)
- 10mm wrench/socket
- Flathead screwdriver
- Wire strippers
- Electrical tape
- Pliers
Procedure
- Disconnect battery – Negative terminal first. Safety non-negotiable.
- Locate old horn – Typically behind front bumper, near radiator support.
- Remove mounting nuts – 10mm, usually two. Penetrating oil helps if rusted.
- Disconnect wiring – Pry connector gently with screwdriver. Note polarity if unmarked.
- Remove old unit – Compare with new horn for mounting compatibility.
- Install new horn – Reverse order: mount, connect wires (match polarity), tighten nuts.
- Reconnect battery – Negative last.
- Test – Press steering wheel pad. Should sound immediately.
Troubleshooting
- No sound? Recheck ground connection and wire seating.
- Weak sound? Adjust bracket aim toward front grille.
- Still dead? Test horn directly with battery – if it works, check relay/fuse.
When in doubt, a mechanic's diagnostic fee beats guessing.