1. Gather your materials. You will need a new set of strings, a string winder, and a pair of wire cutters.
2. Prepare your guitar. Place your guitar on a flat surface, such as a table or workbench. Make sure that the neck of the guitar is pointing away from you.
3. Remove the old strings. Start by loosening the tuning pegs at the head of the guitar until the strings are slack. Once the strings are slack, you can use the wire cutters to cut them off at the bridge.
4. Install the new strings. Start by threading the new strings through the holes in the bridge. Then, pull the strings up and over the saddle and the nut. Finally, attach the strings to the tuning pegs and begin tuning them up.
5. Tune your guitar. Once all of the strings are installed, you can tune your guitar using a tuner. You can also use a tuning fork or the harmonic of the 12th fret to tune the guitar.
Here are some additional tips for changing the strings on your Washburn Rover guitar:
* Be sure to use the correct string gauges for your guitar. The string gauges are typically listed on the guitar's headstock or in the guitar's owner's manual.
* When you are winding the new strings onto the tuning pegs, be sure to wind them in the correct direction. The strings should be wound so that they are tight against the tuning pegs and do not slip.
* When you are tuning your guitar, be sure to tune each string to the correct pitch. You can also use a tuner to tune the guitar.
By following these steps, you can easily change the strings on your Washburn Rover guitar and get back to playing your favorite music.