How to Repair a Broken Guitar Neck: Advanced Guide (Pro Recommended)
⚠️ WARNING: Neck repair requires woodworking precision, clamp strategy, and finish matching. A bad repair ruins playability and value. If unsure, hire a luthier. Typical pro repair: $300–$800+. A ruined neck = total loss.
If You Proceed (At Your Own Risk)
- Tools & Materials
Neck clamp / bench vise with soft jaws, multiple bar/pipe clamps, guitar-specific wood glue (Titebond Original, Franklin, or hide glue), sandpaper (120→400 grit), finish supplies (nitrocellulose lacquer, polyurethane, or matching), replacement truss rod/nut/fretboard if needed, straightedge, feeler gauges.
- Prep
Clean, stable, well-lit workspace. Remove all strings. Tape off body/finish near joint.
- Disassemble
Bolt-on: remove neck bolts. Set-neck: do not force—steam joint if needed (advanced). Through-neck: stop; this is not a DIY repair.
- Assess Damage
Clean break? Splintered? Missing wood? Crack location (heel, headstock, mid-neck)? Headstock breaks (angled back) are most common—and most repairable.
- Dry-Fit & Align
Mate surfaces perfectly. No gaps. Check alignment: neck angle, centerline, scale length. Use alignment pins (bamboo skewers in glue holes) if needed.
- Glue
Apply glue liberally to both surfaces. Work into pores. No dry spots.
- Clamp Strategically
Cauls (shaped wood blocks) distribute pressure. Clamp gradually, evenly—alternate sides. Target 150–250 psi. Wipe squeeze-out immediately with damp cloth.
- Cure
24 hours minimum (Titebond). 48+ for hide glue. Stable temp/humidity.
- Cleanup & Shaping
Remove clamps. Scrape excess glue. Sand joint flush. Match original neck profile (calipers help).
- Finish
Match sheen/color. Nitrocellulose for vintage; poly for modern. Thin coats, sand between. 1–2 weeks full cure.
- Reassemble & Setup
Reattach neck. Install truss rod (if removed). Level/crown frets. Cut nut. Set action/intonation. String up.
When to Absolutely Call a Pro
- Through-neck / set-neck with complex joint
- Headstock splintering into multiple shards
- Vintage / high-value instrument
- No woodworking experience
Your guitar deserves a straight neck. Pay the luthier.