Arts >> Music >> Music Basics

Installing an Aftermarket CD Player in a 1999 Jeep Grand Cherokee (WJ)

Replacing the factory radio in a 1999 Jeep Grand Cherokee (WJ generation) with an aftermarket CD player is a manageable DIY project. Here's a concise guide.

Tools & Materials

Step-by-Step

  1. Disconnect negative battery terminal (10mm wrench). Wait 2 min for airbag capacitor discharge.
  2. Remove bezel: Pry off the trim panel around radio/HVAC (start at bottom). Unplug hazard switch, rear defrost, etc.
  3. Unbolt factory radio: Four 7mm bolts (two each side). Slide unit out.
  4. Disconnect factory harnesses: Main plug + antenna (pull straight out).
  5. Prepare new harness: Match wire colors on adapter to new head unit harness (standardized: yellow=constant 12V, red=switched 12V, black=ground, orange=illum, blue/white=amp turn-on, speaker pairs). Solder + heat shrink for reliability.
  6. Mount new head unit into dash kit brackets, then kit into dash. Secure bolts.
  7. Connect harness adapter, antenna adapter, SWC interface (if used).
  8. Reconnect battery. Test all functions: radio, CD, Bluetooth, steering controls, balance/fade, sub out.
  9. Reinstall bezel. Snap all clips securely.

Pro Tips

If uncomfortable with wiring, a pro install ($100–$200) ensures safety and functionality.

Music Basics

Related Categories