THe MG10/2 mixer allows you to play or record up to ten inputs simultaneously, using ten 1/4-inch audio jacks for guitars and other analog instruments, four XLR jacks for professional microphones and two sets of RCA jacks for tape decks, turntables and other playback devices. By connecting to one or both of left/right jacks on each channel, you can choose between stereo and monophonic sound.
The Auxiliary "Send" and "Return" jacks allow you to feed your audio mix through an effects processor and return it to your MG 10/2 with your chosen effects. Just use TRS cables to connect the "Send" jack to your processor's input jack, connect the "Return" jack to your processor's output jack.
The MG 10/2 contains two sets of outputs. The Control Room outputs allow you to monitor your audio mix using monitor speakers, while the studio outputs allow you to transmit your mix to a recording booth, stage box or other location.
Many professional vocal microphones, particularly condenser microphones, require a Phantom power source in order to pick up and transmit audio. The MG 10/2 comes equipped with a Phantom switch that you can turn on or off as needed.
Each channel contains three green EQ knobs. Each knob corresponds to a frequency range, with the highest knob corresponding to high or treble frequencies, and the lowest knob corresponding to low or bass frequencies. Adjust these knobs to set your desired frequency ranges for each input.
If the input volume of your mix at any time exceeds the mixer's maximum output range, the vertical "Peak" monitor on the right side of the device will warn you by displaying red lights near the top of the column. If you exceed your output abilities, your sound will become distorted -- a process known as clipping, so watch your Peak column carefully and lower your master volume or channel volume levels if necessary.