Connecting TV to DVD Surround Sound System: Step-by-Step
Modern setup typically uses HDMI ARC/eARC. Legacy analog/DVD-only steps below.
Modern Standard: HDMI ARC / eARC (Recommended)
- Connect DVD/Blu-ray player → TV HDMI input (any).
- Connect TV HDMI ARC/eARC port → Soundbar/Receiver HDMI ARC/eARC port.
- Enable HDMI-CEC (Anynet+, Bravia Sync, SimpLink, etc.) on both TV and audio device.
- Set TV audio output: External Speaker / Receiver / ARC (not TV speakers).
- Set receiver input to TV / ARC.
- Test: Play DVD → video on TV, audio through surround.
Legacy: DVD Player (No HDMI) + Receiver
- Video: DVD → TV via Component (YPbPr: red/blue/green RCA) or Composite (yellow RCA) or S-Video.
- Audio: DVD → Receiver via Optical (TOSLINK) or Coaxial digital, or 5.1ch Analog (6 RCA).
- TV audio off; receiver input = DVD/BD.
Legacy: DVD Player → TV Only (No Receiver)
- Use TV's internal speakers (stereo only).
- Or: TV optical out → soundbar with optical in.
Critical Settings
- DVD Player: Audio output = Bitstream / Dolby Digital / DTS (not PCM) for surround.
- TV: Pass-through / Auto for digital audio; disable internal speakers.
- Receiver: Auto-decode; speaker setup (distances, levels, crossover).
Troubleshooting
- No sound? Check ARC enabled on both devices; try different HDMI cable (certified 48Gbps for eARC).
- Lip sync? Adjust "Audio Delay" / "AV Sync" on TV or receiver (+50–150ms).
- Only stereo? Ensure DVD player sends Bitstream; receiver shows "Dolby Digital" / "DTS" indicator.
- DVD has no HDMI? Use component video + optical audio to receiver.
Simplest modern path: Blu-ray player (HDMI) → TV (HDMI) → Soundbar/Receiver (HDMI ARC). One remote (CEC), full surround.