Loosen the elevation bolts by turning them with a wrench. Loosen the bolts only enough so that you can move the dish slightly in a vertical and horizontal direction.
Gently turn the dish to find the strongest signal. Begin by turning the dish to the left.
Pause for a few moments each time you move the dish. Continue to turn the dish and pause every few seconds to check the dish's signal-strength meter.
Move the dish slowly in the opposite direction. Continue to move and pause every few seconds until you again receive the highest reading on the dish's signal-strength screen. Tighten the bolts that regulate the dish's horizontal movement.
Move the dish in an up-and-down direction. Monitor the signal-strength display to determine where the dish gets its best reception. Tighten the elevation bolts.