Arts >> Magic >> Magic Tricks

Repairing a 1970s MXR Flanger Pedal (LED Works, No Effect)

Symptom: LED lights → power/footswitch OK; no flanging → audio path failure.

DIY Troubleshooting (Requires Soldering Skills)

  1. Open enclosure – 4 bottom screws; note wiring.
  2. Visual inspection – Burnt components, cracked solder, corroded battery clip, broken jack contacts.
  3. Check voltages – 9V at battery snap; regulated rails (if any); test points per schematic.
  4. Signal trace – Audio probe: inject signal at input, follow through op-amps (typically 4558/3403), BBD (MN3007/MN3207), clock, output buffer. Loss point = fault.
  5. Common Failures:
    • BBD (bucket-brigade device) – obsolete, hard to source; socketed? test/replace.
    • Clock generator (CD4047/4013) – no LFO sweep = no flange.
    • Electrolytic caps (dry/leaky) – recap entire board.
    • Footswitch / jacks – intermittent.
    • Op-amps – socketed? swap test.
  6. Replace faulty parts – Use quality replacements (film caps, low-noise op-amps).
  7. Reassemble & test.

Professional Repair

Vintage pedal techs: Analog Man, Chicago Music Exchange, local amp/pedal shops. Bench fee ~$50–$100 + parts.

Cost vs. Replace

Original '70s MXR Flanger: $300–$600+ used. Repair often < replacement cost if BBD/clock OK. If BBD dead, NOS chips $50–$150; may exceed value. Sentimental/historical value may justify repair.

Magic Tricks

Related Categories