Why Your Chainsaw Stalls: Fuel, Air, Spark, Compression Checklist
Here's a diagnostic checklist for a stalling chainsaw, ordered from most to least common causes.
Fuel System (Most Common)
- Empty/old fuel: Gas >30 days = varnish. Drain, fresh mix (50:1 or 40:1 per manual).
- Clogged fuel filter: In-tank sock; replace annually.
- Carburetor: Gummed jets, stiff diaphragm, metering lever off. Clean/rebuild.
- Fuel line cracks: Air leaks lean mixture.
Air System
- Dirty air filter: Clean (wash foam, tap paper) or replace.
- Blocked intake: Sawdust in flywheel/fan housing.
Ignition
- Fouled plug: Black/sooty = rich; white/blistered = lean. Replace (NGK/Champion per manual).
- Bad coil: Tests OK cold, fails hot. Check spark with tester.
- Loose kill wire: Grounds intermittently.
Mechanical
- Chain brake engaged: Lever forward = locked. Pull back.
- Low compression: Worn ring/cylinder (<100 psi = rebuild).
- Overheating: Clogged cooling fins, lean mix, dull chain.
- Clutch issues: Springs broken, drum grooved.
Diagnostic Order
- Fresh fuel + clean filter
- Air filter
- Spark plug
- Carb adjustment (L/H/idle screws)
- Compression test
Safety
Never troubleshoot running saw. Chain brake ON. Plug wire off. If unsure → dealer. Stalling saws kick back.