How to Remove Doors from a Jeep Grand Cherokee: Step-by-Step Guide
⚠ Safety First: Doors are heavy (40–60 lbs each). Use a helper or door cart. Disconnect battery if equipped with power windows/locks.
Tools Required
- Socket set (10mm, 13mm)
- Wrench set
- Screwdrivers (Phillips, flathead)
- Pry bar / trim tool
- Torx bits (T40/T45 for some models)
- Masking tape (to mark hinge alignment for reinstall)
Front Door Removal
- Park on level ground, parking brake engaged, ignition off.
- Open door fully. Disconnect wiring harness at body pillar (push tab, pull apart).
- Remove door strap/check link bolt (13mm) from body.
- Mark hinge positions with tape/marker on both body and door.
- Support door weight. Remove 3 hinge-to-body bolts (10mm) — top, middle, bottom.
- Remove 2 hinge-to-door bolts (13mm) at bottom of door.
- Lift door straight up off hinge pins. Set on padded surface.
Rear Door Removal
- Open rear door. Disconnect wiring harness.
- Remove door strap bolt (13mm) from body.
- Mark hinge alignment.
- Remove 2 hinge-to-body bolts (10mm) — top, middle.
- Remove 1 hinge-to-door bolt (13mm) at bottom rear.
- Lift door off hinge pins.
Reinstallation
Reverse steps. Align to marks. Torque bolts to spec (typically 10mm: 25 ft-lbs; 13mm: 45 ft-lbs). Reconnect wiring. Test alignment—adjust hinges if gaps uneven.
Note: Procedure varies by generation (WJ, WK, WK2, WL). Consult factory service manual for your specific year.