How to Connect an Amplifier Kit to a Factory Car Radio
Connecting an Amplifier Kit to Factory Car Radio
Step 1: Prepare the Vehicle
- Park on level surface, engage parking brake, turn off engine.
- Open hood and disconnect negative battery terminal.
Step 2: Access the Radio Wiring
- Remove radio faceplate to expose wiring harness (consult owner's manual).
Step 3: Identify Speaker Wires
- Locate color-coded speaker wires (e.g., Front Left, Front Right, Rear Left, Rear Right).
Step 4: Connect Speaker Outputs to Amplifier
- Match each speaker wire to corresponding input on amplifier.
Step 5: Power and Ground Connections
- Run 4–8 gauge power wire from battery positive to amp's power terminal.
- Connect amp's ground terminal to clean metal chassis point.
Step 6: Remote Turn-On Wire
- Connect radio's remote output to amp's "REM" terminal.
Step 7: Reconnect Battery & Test
- Double-check connections, reconnect negative battery terminal.
- Turn on stereo, play music at low volume, adjust gain.
Step 8: Mount Amplifier & Run Speaker Wires
- Secure amp in ventilated location.
- Run new speaker wires from amp to speakers if needed.
Step 9: Tune the System
- Adjust crossover frequencies, bass boost, gain to taste.
Note: Wiring details vary by kit and vehicle. Consult a professional if unsure.