Wiring an Astatic D104 Mic to a Siltronix 1011D Radio – Step-by-Step
Materials Needed
- Astatic D104 microphone
- Siltronix 1011D radio
- 2-conductor shielded cable (RG-58 recommended)
- Soldering iron, wire strippers, screwdriver
Procedure
- Power off and unplug the radio.
- Remove the radio cover.
- Locate the 1/4″ TRS (3-conductor) microphone jack.
- Strip cable ends 1/4″.
- Solder the shield to the jack’s ground (sleeve).
- Solder conductor 1 to the tip (audio).
- Solder conductor 2 to the ring (if needed for PTT or bias).
- Reassemble the radio.
- Plug in the mic, power on, and adjust gain.
Important: Confirm the exact pinout in your Siltronix manual—some models use different wiring. If unsure, consult a qualified radio technician.