Installing a Whammy Bar on an Aria Pro II Fullerton Guitar
Yes, you can install a whammy bar (tremolo arm) on an Aria Pro II Fullerton. The installation requires basic tools and careful drilling. Note: Modifying a guitar may affect its value and structural integrity; consider consulting a professional luthier.
Tools & Materials
- Whammy bar kit (threaded rod, spring, locking nut, arm)
- Drill with 1/4-inch and 3/8-inch bits
- Screwdriver, hammer, punch
Installation Steps
- Mark the center of the guitar body just below the bridge.
- Drill a 1/4-inch hole at the mark for the threaded rod.
- Drill a 3/8-inch hole ~1/2-inch deep at the same spot for the spring.
- Insert the threaded rod, place the spring, and screw on the locking nut.
- Tighten the nut securely.
- Adjust spring tension with a screwdriver.
- Create a small divot with hammer and punch for the arm rest.
- Attach the whammy bar arm to the rod.
- Tune the guitar and test.