How to String an Epiphone Bass Guitar: 8-Step Process
- Tools ready: Bass, string set, string winder, Phillips screwdriver, wire cutters
- Remove old strings: Loosen tuning pegs counterclockwise; lift off bridge
- Thread new string: Through bridge hole, over saddle, back through hole (string-through-body) or into tailpiece slot
- Attach to tuning post: Insert through hole, wrap 3+ times tightly downward
- Trim excess: Leave 2–3 inches past post
- Tune to pitch: Use winder, then fine-tune by hand
- Repeat for all strings (typically E-A-D-G low to high)
- Check intonation: 12th fret harmonic = fretted 12th; adjust bridge saddle forward/back if off
Epiphone-Specific Notes
- Most Epiphone basses: 34" scale, string-through-body or stop tailpiece
- Thunderbird: reverse headstock — wind opposite direction
- Jack Casady: hollowbody, different bridge — check manual
Fresh strings transform a bass's voice. Change them before they sound dead—not after.