This is a condensed reference. For full safety/warranty info, download the official PDF from Fender.com or consult the printed manual.
| Control | Function |
|---|---|
| Input | 1/4" instrument input (passive/active bass) |
| Gain | Preamp drive / distortion level |
| Volume | Master output level |
| EQ: Bass / Mid / Treble | 3-band passive (100 PR) or active (420) tone stack |
| Contour | 3-way mid-scoop switch (Flat / Scoop / Deep) |
| Effects Loop | Send / Return (series, line level) for pedals/rack gear |
| Headphone Out | 1/4" stereo – mutes speaker for silent practice |
| Power Switch | On/Off (with standby on 420) |
Plug headphones into front jack → speaker mutes automatically. Great for late-night woodshedding.
| Symptom | Likely Causes |
|---|---|
| No power | Fuse, power cord, outlet, standby switch (420) |
| No sound / low output | Speaker cable, cab impedance mismatch, Gain/Vol too low, FX loop return unplugged (if loop engaged) |
| Excessive hum/buzz | Ground loop (lift DI ground), bad instrument cable, single-coil pickup near transformer |
| Distortion unwanted | Gain too high, active bass battery dying, preamp tube (if tube pre section) |
| FX loop silent | Loop not engaged, send/return swapped, pedal bypassed, cable fault |
| Spec | Bassman 100 PR | Bassman 420 |
|---|---|---|
| Power (RMS @ 4Ω) | 100 W | 420 W |
| Preamp | Solid-state | Solid-state |
| EQ | 3-band Passive | 3-band Active |
| Contour | 3-way Switch | 3-way Switch |
| Effects Loop | Yes (Series) | Yes (Series) |
| Headphone Out | Yes | Yes |
| Line Out (XLR) | Yes | Yes |
| Footswitch | Optional (2-btn) | Optional (2-btn) |
| Dimensions (W×H×D) | 19" × 10" × 11" | 23" × 12" × 13" |
| Weight | 35 lbs (16 kg) | 55 lbs (25 kg) |
Support: Fender Consumer Relations – 1-844-202-0924 / support.fender.com.