Arts >> Music >> Musical Instruments

Ampeg VT60 Fuse Location and the Missing Reset Switch

When your Ampeg VT60 goes silent mid-gig, panic is understandable—but the fix is often simple. Here's what you need to know about the fuse and why there's no reset button.

Fuse Location and Replacement

The VT60's fuse sits on the rear panel, adjacent to the AC power inlet (IEC connector). The chassis prints the rating—typically T3.15A 250V (slow-blow/time-delay). Critical: Replace only with the exact same type and rating. A fast-blow fuse will nuisance-blow; a higher rating risks transformer damage.

To replace: unplug the amp, unscrew the fuse holder cap (usually a quarter-turn), swap the fuse, reseat the cap, and test. If the new fuse holds, you're back in business.

No Reset Switch—And Why That Matters

The VT60 does not have a reset switch. Some amps include a breaker-style reset for speaker protection circuits; the VT60 relies solely on the mains fuse. If replacing the fuse doesn't restore operation—or if the amp exhibits no sound, distortion, overheating, or unusual noise—stop. Do not open the chassis.

Tube Amp Safety: Not Optional

Tube amplifiers store lethal high voltages (often 400V+) in filter capacitors even when unplugged and turned off. These can discharge through you if you touch the wrong terminal. Only qualified technicians should perform internal work. The cost of a bench fee is trivial compared to the risk.

Bottom line: Check the rear-panel fuse first. If that's not it, call a pro.

Musical Instruments

Related Categories