Arts >> Music >> Musical Instruments

Why a Browning A5 Won't Extract Low-Brass Shells

The Browning A5 (Auto-5) is a long-recoil semi-auto. Low-brass (light target) shells generate less recoil energy, which can fail to fully cycle the action. Common causes:

  1. Friction Ring Setting — The #1 Cause: The friction ring (bronze piece on magazine tube) MUST be set for the load.
    • Low Brass / Light Loads (2¾" 1 oz, 7/8 oz): Ring FORWARD (toward receiver), beveled edge facing receiver.
    • High Brass / Heavy Loads: Ring BACKWARD (toward forend), flat edge facing receiver.

    Wrong setting = short cycling / failure to extract.

  2. Weak / Broken Recoil / Return Spring: The long spring in the stock loses tension over decades. Insufficient force to pull bolt back fully with light loads.
  3. Dirty / Gummed Chamber: Carbon buildup grabs the thin low-brass hull. Polish chamber with bronze brush + solvent.
  4. Worn / Bent Extractor: Extractor claw doesn't engage the thin rim of low-brass hull reliably.
  5. Weak Extractor Spring: Doesn't hold extractor tight to rim.
  6. Damaged Hulls: Dented/oversized cheap hulls.
  7. Insufficient Lubrication: Friction in receiver rails/bolt slows cycle.

Fix Sequence: 1) Verify friction ring setting for light loads. 2) Deep clean chamber & action. 3) Inspect/replace recoil spring (Wolff Gunsprings). 4) Inspect extractor & spring. 5) Test with high-quality high-brass shells to isolate load vs. gun issue.

Musical Instruments

Related Categories