Materials needed:
- Ukulele
- New set of strings
- String winder
- Wire cutters
- Tuner
- Small screwdriver
Step 1: Remove the old strings
Use the string winder to loosen (turn counterclockwise) the strings until there is no more tension. Then, carefully remove them by unthreading them from the tuning pegs and the bridge.
Step 2: Prepare the new strings
Take a new string and measure it against the length of your ukulele. Leave about an inch or so extra. Cut off the excess using the wire cutters.
Step 3: Secure the strings to the bridge
Feed the end of the string through the hole in the bridge. Then, double it back on itself and tuck the end under the string to create a knot.
Step 4: Begin stringing the tuning pegs
Starting with the lowest-pitched string (A), insert the end of the string into the corresponding hole in the tuning peg. Leave about an inch or so of string sticking out.
Step 5: Wind the strings around the tuning pegs
Using the string winder, begin to wind the string around the tuning peg in a clockwise direction. Make sure the strings are evenly wound and that there are no gaps between them.
Step 6: Tune the strings
Once all the strings are wound, begin tuning them to their proper pitch using a tuner. Start with the lowest-pitched string (A) and work your way up to the highest-pitched string (G).
Step 7: Secure the strings with the small screwdriver
After tuning the strings, use the small screwdriver to tighten the screws on the tuning pegs. This will help to keep the strings from slipping.
Step 8: Cut off the excess string
Use the wire cutters to cut off the excess string at the tuning pegs, leaving about ⅛ inch.
Congratulations! You have successfully strung your ukulele and it’s now ready to play. Remember, it’s important to tune the strings regularly to keep your ukulele in tune and sounding its best.