Gather the necessary tools and supplies, including a Phillips head screwdriver, a flat head screwdriver, and a pry tool.
Turn off the vehicle and disconnect the negative terminal of the battery to prevent any electrical accidents.
Locate the two screws holding the radio faceplate in place on either side of the radio. Use the Phillips head screwdriver to remove these screws.
Gently pry the radio faceplate off using the flat head screwdriver or pry tool. Be careful not to damage the surrounding trim.
Locate the four screws holding the radio in place inside the dash. Use the Phillips head screwdriver to remove these screws.
Carefully slide the radio out of the dash. Disconnect the wiring harness and antenna connector from the back of the radio.
Remove the radio from the vehicle.