How to Remove the Stock Radio from a Holden VS Commodore
Removing the factory radio from a Holden VS Commodore (1995–2000) is a straightforward DIY task.
Tools Needed
- Phillips head screwdriver (#2)
- Flathead screwdriver (for prying)
- Pliers (for stubborn connectors)
- Optional: Penetrating oil (PB Blaster, WD-40) for seized screws.
Step-by-Step
- Disconnect Battery: Remove negative (-) terminal first. Prevents shorts, airbag faults, and ECU resets. Wait 5 mins.
- Remove 4 Mounting Screws: Two on each side of the radio faceplate (visible when ash tray/coin tray is open or behind small caps).
- Pull Unit Out Gently: Grasp the radio chassis (not the faceplate) and pull straight back. Mind the wiring harness—it has limited slack.
- Disconnect Harnesses: Typically 1 large main connector (power, speakers, antenna) + 2 smaller connectors (steering wheel controls, amplifier remote, dimmer). Press release tabs; pull straight out.
- Remove Antenna Lead: Pull the thick coaxial antenna plug from the rear.
- Remove Unit: Radio is now free.
Pro Tips
- Stuck Screws: Apply penetrating oil, wait 10 mins. Use correct size Phillips bit; apply downward pressure while turning.
- Stuck Unit: Use flathead wrapped in tape to gently pry from dashboard clips. Do not force.
- Wiring: Label connectors with tape if not reinstalling identical unit. Aftermarket harness adapters exist.