Removing the Alternator on a 2001 Jeep Cherokee 4.0L: Step-by-Step Guide
Replacing the alternator on the 4.0L inline-six is a straightforward afternoon job if you have the right tools and follow the sequence below.
Tools Required
- 10 mm & 13 mm sockets
- ½" breaker bar
- 10" extension
- Screwdriver & pliers
- Torque wrench (for reinstallation)
Removal Procedure
- Disconnect the battery – Remove the negative terminal (10 mm). Secure the cable away from the post.
- Release the serpentine belt – Insert the breaker bar into the tensioner’s 3/8" square drive, rotate clockwise to relieve tension, and slip the belt off the alternator pulley.
- Disconnect electrical connections – Unplug the voltage-regulator connector; remove the B+ terminal nut (10 mm). Label wires if needed.
- Remove bracket bolts – Two 13 mm bolts: upper bracket to engine, lower pivot to block.
- Extract the alternator – Wiggle free; gentle prying may be needed. Note any spacer or shim positions for reassembly.
Reinstallation Torque Specs
- Bracket bolts: 40–50 ft-lbs
- B+ terminal: 8–10 ft-lbs
- Belt tension: Automatic tensioner (no spec); verify rib seating on all pulleys.
Pro Tips
- Photograph the wiring and belt routing before disassembly.
- Replace the serpentine belt if it has >60k miles or shows cracking.
- Clean mounting surfaces to ensure good electrical ground.