Connecting a Kickdown Cable to a 2-Barrel Carburetor
To install a kickdown cable on a 2-barrel carburetor:
- Locate kickdown linkage on passenger side near throttle linkage.
- Remove cotter pin securing linkage.
- Insert cable end into linkage hole.
- Reinstall cotter pin to secure.
- Adjust cable for slight slack at closed throttle.
Tips:
- Route cable clear of moving parts, heat sources.
- Trim excess length with cable cutters if too long.
- Use extension cable if too short.
- Verify full throttle opens kickdown fully.
Proper adjustment ensures transmission downshifts correctly under acceleration.