A creaking noise from the rear of a 1987 Honda Accord that appears both while driving and when entering or exiting the vehicle points squarely to a suspension or chassis component affected by load changes. Because the noise occurs with weight shifts (getting in/out) as well as road imperfections, the culprit is likely a joint or bushing that articulates under both conditions. Here's a diagnostic roadmap, ordered from most to least probable.
These connect the sway bar to the rear control arms. The ball joints inside the links are notorious wear points on this generation Accord. When they fail, they produce a distinct creak or clunk over bumps and whenever the body rolls or weight transfers—exactly the symptoms described. Inspect for torn boots, play in the joint, or seized movement.
The rear trailing arms and upper/lower control arms rely on rubber bushings that, after 30+ years, inevitably dry-rot. This allows metal-on-metal contact as the suspension articulates or the chassis flexes under load. Look for cracked, collapsed, or oil-soaked bushings. A pry bar test can reveal excessive movement.
Leaking fluid or worn internal valves can generate noise, but don't overlook the upper shock mounts and bushings. A deteriorated upper mount allows the shock piston to knock or creak against the body structure.
Always verify wheel torque first. Loose lug nuts allow the wheel to shift microscopically on the hub face, creating a creak that mimics suspension noise. Torque to spec (80 ft-lbs for this model) and recheck.
Note: The 1987 Accord uses coil springs in the rear, not leaf springs. A broken coil spring typically causes a clunk and noticeable ride-height difference, not an intermittent creak.
Have an assistant bounce the rear bumper while you listen underneath with a mechanic's stethoscope (or a long screwdriver pressed against components). Spray suspect bushings with silicone lubricant; if the noise disappears temporarily, you've confirmed the worn bushing.