• New oil pan
• Oil pan gasket
• Oil filter
• Oil
• Wrench set
• Socket set
• Jack
• Jack stands
• Safety glasses
1. Park the Jeep on a level surface and engage the parking brake.
2. Raise the front of the Jeep using a jack and place it on jack stands. Make sure the Jeep is securely supported before crawling underneath.
3. Locate the oil pan. It is a flat, metal pan located under the engine.
4. Remove the oil drain plug from the oil pan and allow the oil to drain into a drain pan.
5. Once the oil has drained, remove the bolts holding the oil pan in place.
6. Carefully remove the old oil pan and gasket. Be careful not to spill any oil.
7. Clean the mating surface of the engine block where the oil pan will mount.
8. Apply a thin layer of gasket maker to the new oil pan gasket.
9. Install the new oil pan gasket on the engine block.
10. Install the new oil pan and bolts. Tighten the bolts in a criss-cross pattern to ensure an even seal.
11. Replace the oil drain plug.
12. Add new oil to the engine.
13. Start the engine and let it run for a few minutes. Check for any leaks.
14. Lower the Jeep from the jack stands and remove the jack.